Sioux Industrial Water Heaters

Sioux is a leader in providing industrial equipment for cold weather pouring of concrete. Hot water heaters are ideal for pre-cast and ready-mixed concrete applications. With a Sioux water heater, pouring can be done later in the Fall and earlier in the Spring, increasing profits. In addition, studies show that pouring with hot water (during any season) increases the quality of concrete.

Units provide instantaneous, continuous hot water supply, with no preheating and no recovery time needed. Operation is simple. A 100oF temperature rise can be reached in only 3-5 minutes (depending on unit rating). Outlet temperatures and flow rate can be held at precise levels. Units are pre-plumbed and pre-wired for easy installation.

Standard water heater sections are available in 1-3 million BTU/Hour. Units are modular so that only a minimal investment is required to start, then systems can be expanded as your operation grows. Oil, LP or natural gas burners are available; or a combination burner which will burn any of the above fuels. Units are built to Section IV of ASME Code and are registered with the National Board of Boiler and Pressure Vessel Inspectors.

With a vast background in this field, Sioux has been providing water heaters to the ready mixed and precast concrete industries for over 30 years, has been manufacturing quality industrial equipment since 1939. Consult factory for assistance with sizing a water heater section to meet your concrete needs!

	Basic Water Heater (D Series) Ideal for smaller volumes of water for direct feed into your ready mix truck. Great add-on to your present water heating system.
	Water Heater with Circulation Pump (M Series) Our most popular model incorporates the same basic unit as the basic water heater, plus pumping stations for recirculating hot water to the customer's holding tank. This system is designed for applications where there is a need for a large quantity of water in a short time period.
	Water Heater System with 1,000 Gallon Tank and Pump (HWP Series) Ideal for remote locations or construction sites, such as dams or bridges. This series combines the rugged Sioux Water Heater/Pumping System of the M Series with a 1,000 gallon atmospherically-vented water tank.
	Water Heater System with 225 Gallon Tank and Pump (PWP Series) Designed for applications such as precast, pipe, vault, prestress, or block operations, where hot water is needed on a constant basis, with a smaller tank than the HWP series.
	The M-415 Heater designed for used on Volumetric Mobile Mixers. Heater can be mounted on truck. Click on brochure link below for more information.